UNDER BODY REFERENCE VALUES > THREE-DIMENSIONAL DISTANCE


HINT:
  1. Measure points with the engine under cover NO.1 and front floor cover removed.
  2. Point A, a and B, b on the vehicle are asymmetrical.
  3. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Side Rail Reinforcement Rear Installation Bolt
M12 (0.47)
B, b
Side Rail Reinforcement Rear Installation Bolt
M12 (0.47)
C, c
Front Suspension Member Installation Bolt
M14 (0.55)
D, d
Front Suspension Member Installation Bolt
M14 (0.55)
E, e
Front Side Member Standard Hole
φ18 (0.71)

K100470E01